What do I need to do to enable the SIP Proxy?

We will setup the SIP Proxy and point it to your PBX. All you will need to do is allow the traffic to reach your PBX by allowing the SIP Proxy IP/DNS via the PBX firewall.

Then you will simply configure your phone clients to use the SIP Proxy using the settings below (PBX extensions and passwords need to be enabled on the SIP Proxy)

Server: SIP Proxy address
Port: Supplied on signup
Transport: TLS
Username: PBX Extension number
Secret: PBX Extension number secret


  • 379 Users Found This Useful
Was this answer helpful?

Related Articles

Does your SIP Proxy support TLS and SRTP?

Yes, we configure all our SIP Proxies to only allow TLS comms with a verified Letsencypt...

Is the SIP Proxy Monitored?

Yes, we actively monitor your SIP proxy to ensure it is alive and serving traffic corrrectly.We...

Can a SIP proxy operate for Microsoft Teams and other apps and extensions at the same time?

Yes, our SIP proxy can act as both a Microsoft Teams Session Border Controller (SBC) and a SIP...

Do I need a SIP Proxy?

A SIP Proxy is needed if you want to use Microsoft Teams with your PBX, DIDs and SIP Trunk...

Can I share my SIP Trunk Inclusive Minutes bundle across my staff?

Yes, when used with a PBX your SIP Trunk can act as a single outbound route for calls sharing...